Weather Station Setup

By: Wavestorm , 9:56 AM GMT on December 31, 2013

Share this Blog
0
+

Basically, my weather station is a modified La Crosse 2316, operating since 2009. In order to make this rather inexpensive weather station more robust, I made the following modifications:

All solder joints redone using lead based solder to eliminate circuit problems with high vibration in windy conditions.

Conformal coating done on all of the circuit boards.

Cables shortened to eliminate errors in data transmission.

Thermohydro transmitter module mounted into a radiation shield.

Everything runs wireless using batteries to protect against lightning strikes.

Base station connected directly to a Raspberry Pi model B running WView. The RS232 level translator circuit was bypassed to pass LVTTL serial data directly between the unit and the onboard serial port of the Raspberry Pi unit.

Reader Comments

Comments will take a few seconds to appear.

Post Your Comments

Please sign in to post comments.

or Join

Not only will you be able to leave comments on this blog, but you'll also have the ability to upload and share your photos in our Wunder Photos section.

Display: 0, 50, 100, 200 Sort: Newest First - Order Posted

Viewing: 1 - 1

Page: 1 — Blog Index

1. WunderAlertBot (Admin)
5:22 PM GMT on July 16, 2014
Wavestorm has created a new entry.

Viewing: 1 - 1

Page: 1 — Blog Index

Top of Page

About Wavestorm

Wavestorm doesn't have a bio yet.

Recommended Links